Keywords
Quality Control
SPC
FMEA
How to Cite
Abstract
PT. ICP is a company engaged in manufacturing of packaging, with a wide variety of packaging technologies that fit the needs of the current market share. Among the resulting product is a
plastic cup, the results of thermoforming. This research aims to know the main cause of the defect (defect) in a plastic cup products and to reduce product defects in the production process. From the results of the observations made in September 2017 until December 2017 known that the plastic cup products with total production of 63,314,964 pcs to 3,671,341 pcs disability amount. Based on the problems faced by the company efforts on product quality control plastic cup to find the cause of a disability and find solutions for improvement. Proper methods used in the problems that occurred in PT ICP are using Statistical Process Control (SPC) and the method of Failure Mode and Effects Analysis (FMEA). The method is intended to reduce defects in the product and look for the main cause of defect products in a plastic cup. From the results of research conducted has been known that the biggest cause of disability plastic cup is of a rough lip with disabilities amount of 1,346,308 pcs with a cumulative value of 42%. FMEA analysis and the results of that unknown cause rough lip is from wear cutting factor with a value of 224 RPN.
References
Mukti, Mohamad Yusuf Dana, 2015. Pengaruh Kualitas Produk Dan Kualitas Layanan Terhadap Keputusan Pembelian. (Studi Kasus pada Mebel CV Jati Endah Lodoyo Blitar). Universitas STIE Kesuma Negara Blitar.
Kaban, Rendy, 2014. Pengendalian Kualitas Kemasan plastik Pouch Menggunakan Statistical Process Control (SPC) di PT. INCASI RAYA PADANG. Universitas Andalas, Padang.
Surono, Untoro Budi dan Ismanto, 2016. Pengolahan sampah plastik jenis PP, PET dan PE Menjadi Bahan Bakar Minyak Dan Karateristiknya. Universitas Janabadra Yogyakarta.
Devani, Vera dan Fitri Wahyuni. 2016. Pengendalian Kualitas Kertas Dengan Menggunakan Statistical Control di Paper machine 3. JITI. Vol.15 (2). Des 2016, 87-93.
Montggomery Douglas C, 1993. “Pengantar Pengendalian Kualitas Statistik”, Gajahmada University Press, Yogyakarta.
Mayangsari, Diana Fitria, dkk. 2015. Usulan Pengendalian Kuaitas Produk Isolator Dengan Metode Failure Mode And Effect Analysis (FMEA) Dan Fault Tree Analysis (FTA). Institut Teknologi Nasional (Itenas) Bandung.
Rachman, Ayunisa, Dkk, 2016. Perbaikan produk ubin semen menggunakan metode Failure Mode And Effect Analysis dan Failure Tree Analysis di Institusi Keramik. Institut Teknologi Nasional (Itenas) Bandung.
This work is licensed under a Creative Commons Attribution 4.0 International License.